5 Commonplace Problems in A Luminous Inverter and Ways to Solve Them

An essential device that will be found in one corner of virtually every home is an inverter. Even schools, offices or public buildings are not exempt from this rule. When push comes to shove, these rectangular gizmos save the day. When there is a power outage, as inevitably happens, it is the inverter that offers an electricity backup. The gist – the value of inverter batteries cannot be emphasised enough.

Now, imagine a scenario. A house has the best of the best inverter installed from one of the preferred APC ups dealers. A few months later, there is an electricity shortage. What ensues next is shocking. Instead of serving as the backup, the inverter fails to run. There is no power to charge a mobile or to run the fan or even switch on the light.

Sadly, this situation is relatively common. Like every other appliance installed in a residence, inverters are prone to glitches. Thankfully, there are some issues that can be fixed at home. Tackled underneath are solutions to the most common problems arising in batteries.

  • The Invert Fails to Switch on

The causes for an inverter to not turn on are manifold:

  1. Tripped Inverter
  2. Disconnected Battery
  3. Weak Battery
  4. Discharged Battery
  5. Loose Terminals
  6. Reversed Terminals
  7. Faulty Switch

For each issue, there is a different way out. A tripped inverter can be resolved by pressing the reset button on the device. If the power switch is causing a problem, get it repaired at a service centre. In case the battery is faulty or defective, a replacement will be needed. For weak batteries, the best answer is to let it charge for some hours, but if it is old, the better choice is to get a new one. For terminal complication, inspect for corrosion, clean the rust and then clamp them back, tightly.

  • Steadily Beeping Alarm

When the inverter is bearing too much load, it begins to blare out the alarm. The only way to stop the beeping is to disconnect every device that is causing an extra burden on the inverter. Another reason the alarm might shriek is when the cooling fan is stuck. The fan is needed to maintain a cool temperature in the system while the inverter is working. If for some reason the fan is not operational, either the inverter will shut down, or the alarm will beep.

The beeping indicates that the unit is not running in a safe condition and needs to be switched off. The key is to clean the fan and get it working again. If neither of the strategies settle the problem, take the inverter to a service centre.

  • LCD Showcases Wrong Codes

A frequent hitch with power inverters that have LCDs is false codes. The displayed numbers could be wrong due to:

  1. External problem
  2. Internal Issue

Internal troubles are generally related to circuits and can only be solved by a qualified professional. External complication can be worked out by:

  1. Inspecting the cables of battery
  2. Checking the output or input wires
  3. Rechecking the load
  • Low Backup Capacity

The one worry that is typical to inverters is a very short backup time. The causes that lead to this problem can encompass the whole gamut:

  1. Too much power consumption – to solve, eradicate all extra load
  2. Incorrectly charged battery – to correct, charge uninterruptedly for few hours.â€<
  3. Low electrolyte level – to resolve, refill the water using only distilled water to the recommended level. Always maintain it somewhere in the middle of minimum and maximum limit.
  • Battery Refuses to Charge

A hiccup that some inverters face is no charging of the battery. This happens when:

  1. Battery is dead
  2. Rectifiers are burnt
  3. Fuses have melted
  4. Connections are loose

The first issue can only be answered by replacing the battery. The solution to the other three is cleaning the terminals for corrosion. If nothing works, then licensed help would be required.

  • Sounds Inside the Inverter

A difficulty that several inverters have is noises coming from the inside of them. The vital point to bear in mind is that each power inverter emanates certain sounds. It is standard. But, at times, the cooling fan collects a lot of dust and debris that produce weird clatters and clinks. Clean the fan. It should take care of the sound. If the noise persists, get the fan changed.

The Gist – Be Handy

There was a time when inverters were a luxury item that few could afford. The present environment of frequent power cuts is not conducive to this thought, anymore. Any place that houses people needs a backup and luminous inverter make excellent options. Knowing how to take care of small glitches that happen in every household appliance can save a lot of headaches. Be handy, learn to resolve little problems related to inverters and save money, effort and time spent on hiring professionals.